Begin knitting with pen sponges:
Knit 8 aircraft (VP), then in the fifth EP on the hook knit a column with nakida (CCH) and in the next 3 EP 1 CCH. We got the first row. Knit 3 EP lift and turn the product on the wrong side. In the second row knit 4 PRS. Here knitting scheme
So we get:
I knit 45 rows of CCH. The handle turned length 44 cm.
Now knit washcloths body. Knit 16 VI. Then get involved connecting bar (SS) in the very first EP (beside her even the tip of the thread sticks out) at the other end of the handle washcloths. Please note that the washcloths pen was not twisted.
Then another 4 SS in the following tabs. Now, we were binding additional 16 VP. And knit mop in the other end of the handle washcloths. The result was a vicious circle. (pictured SS has not knit)
is now the first row knit washcloths body 1 and EP lifting column without nakida (RLS) in the same loop of the previous row, to get involved where SS. Then knit 1 sc in each loop of the previous row in a circle. Closing the circle CC in the first sc.
Second row: 1 VP rise, * 1 sc in the loop of the previous row, knit where the SS, 1 sc, 2 sc in one loop of the previous row, * from * to * repeat to end of row, finish the mop in the first sc. The scheme:
Thus, in the first row, we had 42 loops, and now increased to 56 loops.
At your discretion of increases can be done more often, to sponge was wider, for example every second loop gain to do, and it is better to leave this series of the same, and the next series (optional) to associate once again with the addition. In my knitting bast turns 10 cm wide flat.
Now we start to knit a number of fringe: 1 VP lift, enter the hook in the loop of the previous row, to get involved where the SS, and pull the loop. Get the two loops on the hook:
Now left thumb plant in the thread and the thread is pulled over, presses a finger entwined thread to an article introducing the hook into the next loop of the previous row (with the entwined yarn finger and remain on the right) and pull another loop. We have three loops on the hook (in the photo I took from the thumb loop fringe - it is better not to do so until the end of this loop knit). Now we do nakida on the hook and pull it through all three loops hanging on the hook:
The loop fringe done!
Several fringe knit circle 56 loops. Next to finish the series connection column WILL NOT .
At this point, enter the hook in the first column with a fringe and pull loop
Knit on around the circle until the last loop fringe
The next sc already knit loop fringe.
Do not forget to pull the loop of the previous loop knit - this is what strengthens the fringe! Thus we alternate rows and rows of fringe RLS.
I knit striped washcloth. Change the color is green and knit row sc, then a series of fringe, again a number of RLS and a number of fringe.
next series consists of sc. This series may be incomplete or contrary a little more than a number, because the knit to the point where we will have is a pen washcloths (you notice that the beginning of a number during knitting washcloths body moves to the right? Line and start the series spirals?). The second handle sponges must be at least parallel to the first arm, and the place of their attachment to the body sponges are on the same imaginary line
Now knit 3 air lift loop:
Next 4 CCH
Further 3 EP lift, turn over work and over 4 PRS scheme of knitting the first pen
I knit 45 rows - this is similar to the first handle washcloths. Then connecting the posts to get involved in this end of the handle body sponges. And ...
Your sponge READY!